Monster 2 1:8th 25V Car ESC Waterproof w/ 2650kv Motor
The Castle Mamba Monster 2 Waterproof 1/8 Scale Brushless Combo includes the sensored 1512 2650Kv motor and is recommended for 1:8 scale vehicles and 1:10 scale 4WD SCT up to 9lbs.
The Mamba Monster 2 is an incredibly powerful sensorless ESC capable of 2S to 6S LiPo operation. It's also waterproof, so you can run your vehicle just about anywhere. It features an easy-access case allowing you to replace fans quickly, if necessary. Additionally, Mamba Monster 2 features solder posts, so changing battery wire length is simple.
The 1512 1Y Sensored 4-Pole Brushless Motor combines rotor position sensor technology with an improved high power and high efficiency motor design to deliver ultra smooth startup, precise low speed control, incredible torque, and lightning fast response. Through the use of Castle's Smart Sense technology, the position of the rotor is always known by the ESC, eliminating the possibility of encountering cogging, and allows the 1512 to deliver great throttle control and smooth starts, with the power and run times that Castle motors are known for.
NOTE:
Not intended for operation while submerged in liquid. If unit is operated in wet conditions, rinse with fresh water to remove dirt or corrosives, then fully dry unit. The cooling fan must be removed prior to driving in wet conditions. It is not waterproof.
Motor Features:
Exceptional efficiency, Less heat
Oversized gold plated solder tabs easy soldering
QUIETSENSE Technology shields magnetic field noise generated from the motor
Design eliminates the need for mechanical timing adjustments
Sensor alignment delivers uniform timing/torque in both directions automatically
Rebuildable design
High strength 180*C neodymium sintered magnets
10 AWG high strand wire with silicone insulation
6061-T6 Billet aluminum heatsink can
High RPM NMB oversized bearings
Low resistance gold plated bullet connectors
Motor Specifications:
Input Voltage Range: 2-4S LiPo
Kv: 2650 Max. RPM: 60,000
Length: 67.7mm, Diameter: 40mm (41.1mm w/fins)
Weight (w/wires): 383 g / 13.6oz
Shaft Diameter: 5mm
Mounting Hole Specifications: M3 & M4 @ 25mm
Connectors: 6.5mm
ESC:
Input Voltage Range: 2S - 6S LiPo
BEC Specifications: 5-7 volts; default 5.5 volts
Reversible: Yes, but may be disabled for racing
Cooling Fan: Yes, removable
Length: 2.19" (56mm), Width: 1.86" (47mm), Height: 1.33" (34mm)
Connectors: 6.5mm bullets for motor. No battery connector
Fully programmable using Castle Link
