SJT have introduced these innovative rubber 1/12th scale tires for GT12 pan car classes which offers a simple low cost alternative to foam tires. Where a foam tire is good for 3-4 runs, SJT tires can produce consistent performance for 50-60 runs or more. Developed and tested in the United States, SJT Tires require no change to existing 12th scale chassis. Works well with a spool and minimal spring changes, there is no tire truing, no side wall gluing, no one run tires. Typically the tires are .5 seconds slower per lap but up to 50 times longer life. Rubber tire 12th scale removes the constant ride height adjustment and are ready to race directly out of the package.
Rubber tires for 12th scale GT12 pan cars.
Includes:
One set of 12th scale tires Two Front Two Rear.
Ready to Race right out of the package
No Truing.
No Glueing.
No one run tires
Tire life: with 21.5 USGT Motor 3 hours + of NON Stop racing
Tire Diameter:
Front Tires 41mm
Rear Tires 42mm
Speed:
Rubber tires are .4-.8 tenths slower per lap on most tracks. Dont expect to beat a foam car.
Use this time to appreciate the large sums of money you saved and never needing a tire truer again.
Starting Setup:
SXT 3.0 for 3 min wipe them off till the feel tacky on the paper towel otherwise they feel greasy for 3 laps
Zero reactive castor
1.5 degree camber
6 Degree Castor
.020 front srpings
Soft Center spring 35 wt oil
10k damper tubes
soft side springs
2mm rear droop
Spool on med to high bite Ball diff on low bite Avoid green tracks.
Only one compound
